hi, just had seat back from trimmers but think the back rest been done upside down hopefully someone will be able
to tell from the pics,need to be sure before it goes back think the hump bit is on wrong side if that makes any sense
any help be great....

Certainly don't look right, isn't the back suppose to be closed? Who on earth did the upholstery???

got a separate piece that screws on for back

Shouldn't the top be the same as the bottom as it is a FLIP seat?
Don't know much about these but it doesn't look right.

Just found this thread on thesamba:
http://www.thesamba.com/vw/forum/viewtopic.php?t=276647&postdays=0&postorder=asc&highlight=flips+seat&start=420
Quite interesting in it self but there is a picture half way down the page which shows a flip seat.

I'm sure there are some flip seat specialists on here who can help you.

Gertjan

It looks a little wrong ...however it also looks like you might have it attached upside down.

I think the slightly fatter end of its profile should be at the base in driving position and the top in seating position.

clymoj that's what I was thinking if I fit it the other way up the piping is on bottom ill take it back to be redone
cheers

It certainly looks like it is on upside down - which would fix the orientation of the hump - and it looks like the top tapers & rolls around to a much thinner top profile - so no top piping required as the top is a rolled edge.... I'd turn it over first and take another pic before going back to trimmers.