looking good...
Like the demands being obeyed....
Re you a man or a mouse?
We all go eek eek in the end! LOL

My demand was it has to have OG interior and seats...can't see them now for curtains cushions and chinese lantern fairy lights and hanging hearts and bunting LOL

Coming along nice that Daz, good work dude.

Supposed to be putting on a few miles to get shake down for the run to ebi - problems with engine / carbs so back to stock carb etc

It's only 4 bolts

Tidy looking engine Daz

Cheers

Neil

Gonna have to put this bad boy in - all the chrome will get me home !!

"Bling Bling"......."Bling Bling"


Even I did not think this was for you Daz..
Bet you do not open the engine lid to show that off!

Needs must!

G

Your damn right !! Even has a chrome dump plate !!!
It oozes quali-tay !!!

So got a bit of ribbing about the Neptune blue tin wear so I swapped over the og black tin wear and engine back in . The carb manifold had seen better days as I was going back to a single carb so I got a new one as the old one had blocked pre heat pipes and I've had problems before with carb icing before .

Also who needs a ignition key when a one size screwdriver fits it perfectly

The side door handle had taken a bashing as the bus had been on it's side ( sliding down the road ) , and the metal housing had taken a bashing around the escutcheon which was all wonky .



It was a bugger to get the handle off as it was locked and the hole fir where the key went had been fubbered !

So I got a slide hammer and bent a right angle piece of metal to hook under the skin , a few slides later and it looked / fitted sweeter

Question
Is it going to see EBI ?

Any interior pics Darren

NUGGET wrote:Question
Is it going to see EBI ?

Any interior pics Darren

like my hitop -interior working progress !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

willit or wont it make it to ebi -if not the t5 is on standby , i will bring a towrope for you just in case.

After a few drives and one fuel breakdown I def needed a fuel gauge and since I'm going out led bulb mad on this bus so I liked the look of the v- speed Denhe gauge
- I got a piece of aluminium for the base and curved it so it fitted the profile of the dash - might thin it down a bit as protrudes quite high - but well pleased with the look !

Only got a few gallon in the bay fuel tank at the moment so it's reading low - got to save up to fill the tank up .

What you think

Looks really good...you could get the shape profile matched to the gauge base plate shape as well then the plate at the back would look like an OG fitment.
If done on CNC machine..programing takes the time..
Get several made...Lots would buy!

I didn't know u were a One Direction fan Darren?

Where does one buy a Harry Styles horn push from anyway?

Nige

Put £20 if juice in and got to the next target / level on the fuel gauge - so looks like it's working